Technical Support for
DWX-50 5-Axis Dental Mill
Featured Articles
MillBox - Security Software / Anti-Virus ExclusionsRoland Product End of Life Policy
Software OS Support List
Why is the dust collector necessary?
Search DWX-50 Documents & Knowledge Base Articles
Expand All | Collapse All
Application & Software Guides ( 1 )
Bulletin ( 1 )
Drivers ( 1 )
Maintenance & Calibration Guides ( 3 )
This document will assist DWX-50 users to properly maintain and tighten the collet monthly or every 200 hours of operation.
651.52 KB
Spanish Version - This document will assist DWX-50 users to properly maintain tightning the collet monthly or every 200 hours of use.
323.24 KB
This DWX-50 supplemental maintenance guide has important information for the periodic maintenance that should be completed prior to milling and after milling is completed.
106.32 KB
MSDS ( 1 )
Owner & User Manual ( 10 )
This manula will assist users in the setup and operation of the BOFA DustPRO Base unit for the DWX Dental Mills.
720.01 KB
Technical guide to DWX-50 - English - Includes Product Specification and Customer Testimonial
642.75 KB
16 page users manual on the stand alone BOFA unit
619.68 KB
Setup & Install Guides ( 4 )
This document will walk DWX-50 users through the steps to properly install the latest version of firmware.
169.94 KB
The DWX-50 Setup Maintenance Guide will assist users in initial setup of the machine along with periodic maintenance procedures to assist with regular and daily upkeep.
7.47 MB
This document will assist DWX-50 users in proper installation procedures by using the Tool Positioning Guide for the ATC
356.27 KB
This document will assist DWX-50 users in the proper procedure for installing Dental Tools using the Tool Positioning Fixture for the ATC
485.02 KB
Training Videos ( 5 )
This video will assist DWX users with the proper procedure for collet tightening maintenance
586.41 KB
Get the most value out of your dental milling tools. We take a look at the most popular dental tools being used with Roland Dental Milling devices.
45.05 KB
Follow this link to the Roland Academy Webinars On-Demand webpage. Then filter through the videos to find a training session that suits your needs.
57.43 KB
Knowledge Base Articles ( 15 )
HELP!! I can't find the driver I need for my Roland!
The cut path is being clipped on one side of the print
With Roland limited warranties, you get not only extensive coverage of your device, but the best service and support in the industry. All products come standard with the manufacturers warranty outlined below, with upgrade options available on many products.
The air regulator for the DWX-50 and DWX-4 has a filter located within the clear plastic bottom cup. This filter can sometimes be discoloredand becomeyellow or brown in color.
The air nozzle is not clearing away the cutting dust during the milling process.
What should I do when the regulator drain bowl contains fluid or appears contaminated?
The DWX-50 VPanel Displays an Error Message
My DWX-50 has a fair amount of cutting dust on the X and Z shafts. What steps should I take to clean them?
MillBox - Security Software / Anti-Virus Exclusions
Information about my legacy product
Software OS Support List
Tech Support Terms and Conditions
When outputting a design to your engraver or milling machine, the software needs to be able to translate commands to the device. These commands tell the machine how fast to mill, at what revolutions per minute (RPM), and where to mill in 3D space. This is what makes up a toolpath. A Strategy is a combination of tool movements, material properties, software algorithms, and tool characteristics.
Zirconia being milled on the DWX-50 shows signs of chipping - usually around the margin/edge
Do I really need to purchase this accessory item?